UBEC

DUAL FPV UBEC 5.0V 3A fr 12V 2A Working Voltage 2s~6s LipoOne more imagine high-tech electronic device for FPV devices.High efficiency, suit for Telemetry, Brushless gimbal, Flight controller Power supply use.What it Does:Get Stabilizing 5.0V at 3A or 12V at 2A  from your Lipo Battery, Working ..

One more imagine high-tech electronic device from Gryphon the Pionner in r/c electronicsPort : Input 2CH, Output 2CHComponents : Main unit 1EA, RX cable 2EA, Operating guideIf you running unregulated LiPo or LiFe power to your servos, this regulator will allow you to run regulated current to your se..

Overview: This UBEC is an external switching mode DC-DC regulator; it draws DC voltage from 2-6S LiPo battery, drops it to a voltage level that is suitable for your receivers and other electronic devices, and keeps providing the stable current output of up to 10Amp. As the UBEC has such a powerfu..

Matek 5 in 1 Module Power Distribution Board + LED Control + BEC 5V+ Low Voltage Alarm+ Tracker 4 layers PCB with 2oz cooper. It is a 5in1 HUB with Power Distribution Board, BEC 5V/3A &12V/500mA, LED Light Controller, Lost Plane Finder & Low Voltage Alarm functions. It is specially made fo..

Matek Mini PDB and LDO 12V 500mAh@16V and 12V 200mAh 24V@Features: Mini size PDB saving more space for ESC Using 2oz copper for PCB Board, High current resistant 12V voltage stabilization, to power to the camera Especially fit with axis frame which without PDB Mounting Pitch: 24mm What you..

Matek System 3in 1 with Low Voltage Lipo Battery, Discovery Buzzer, Signal Loss Matek System 3 in 1 input Voltage 2--6S LiPo Battery monitor, Discovery buzzer Signal loss alarm Specification: Size: 20x30x6mm Twin loud buzzers, 85db Input voltage range 2S-6S Lipo Automatically alarms..

The Power Module is a simple way of providing your APM Pro/Pixhawk with clean power from a LiPo battery as well as current consumption and battery voltage measurements, all through a 6-pos cable.The on-board switching regulator outputs 5.3V and a maximum of 2.25A from up to a 6S LiPo battery.The Pow..

Description:The APM  Power Module is a simple way of providing your APM  with clean power from a LiPo battery as well as current consumption and battery voltage measurements, all through a 6-pos cable.  The Power Module comes completely assembled with XT60  connectors, and wrappe..

Adjustable Step Down Voltage Regulator, Input Voltage Range from 4.0~40V (input voltage must be higher than output voltage at least 1.5V). Continuously Adjustable Output Voltage from 1.25V -37V. Guaranteed 2A output load current (maybe it will need a cooling surface for continuous current). The..

FPV BEC 12V 3A for 4s ~ 6s LipoOne more imagine high-tech electronic device for FPV devices.What it Does:Get Stabilizing 12V at 3A  from your Lipo Battery, Working from 4s up to 6s Lipo. You can connect your Wireless Devices (Transmitter, Gimbal, LED, etc..)What you Get:1 x BEC 12V 3A with cabl..

Hobbywing UBEC 3A @ 5/6V with Noise Filter and Ferrite bead for RF Features:Uses an advanced switch mode DC-DC regulator IC. Output is powerful enough even working with 4S to 6S Lipo battery. Battery polarity reversal protection. Metal shield and a filter significantly reduce the electro..

ZMR UBEC V3 8A for RC-Drones, Planes, Boats, etc..Sort Discription: Suitable for multi-rotor aircraft, fixed-wing, FPV, high-power image transmission, etc. (If 12V voltage is required, the input voltage must be higher than 12V) No external power-off switch is included. Switching technology to..

ZMR UBEC V4 8A for RC-Drones, Planes, Boats, etc..Sort Discription: Special purpose for model airplane gasoline engine. Only one battery is used, one power output is supplied to servos, receiver and other devices at the same time, and the other power output adopts optocoupler isolation technolo..